Friday, February 6, 2009

Grinding.. Did I already say that?

Last evening was spent once again, grinding the profiles on the stringers. I managed to finish the rough work on the remaining starboard side stringers. I can't complain too much about the fair curve. I only wish I could have seen another pathfinder to see how their boat curves look. I was asked how I managed to make even cuts with the grinder. The grinder needs to be run along the stringer in order to make a clean even cut, if made in short chops it's only going to look like you used a chainsaw to fair your stringer. Not good.

Time: 2 hrs

No comments:

Post a Comment