Monday, April 6, 2009

Forward floor supports

I Sawed a couple of pieces of wood for the forward floor supports and dry fitted them in place. Some scrap plywood was laid down over floor beams to the hull so I could lay my marks for the edge supports. I marked around small pieces of wood precut and drilled very small pilot holes through the hull. I then drilled and counter sunk the holes from the outside. Mixed up a tiny batch of epoxy and screwed the pieces to the hull.You can see the forward support blocks for possible floor mounted gear, as well as on the sides of the centercase you can see the blocks the will be future drains.

Time: 2 hr

No comments:

Post a Comment